This is 1.2 release version, can unlock  1000 universe 512000 parameters for MA3 2.1.1.5, 2.3.0.4, 2.3.1.1, 2.3.2.0, 2.4.2.2 version.

How to use:
1: install MA3 from Original, don't copy any plugin to MA3 directory.
2: Run MA3 and this MA3_load, in MA3_Load press Connect MA3 then will OK.

Attention: In MA3, choose 127.0.0.1 or the IP of your other MA devices for the Session IP, but do not select
the SL04 box's network card IP, otherwise MA3 will send unnecessary network data to the box, which will occupy
the SL04 box's network bandwidth for a long time. Be careful!

Since this is an official unlocking method, MA3 must be correctly set up for Art-Net/sACN to output data!

How to configure Art-Net / sACN in MA3:
DMX Protocols -> Enable Output, choose the interface where you want the Art-Net/sACN data to be output,
under Data, make sure to change Enabled from No to Yes (right-click mouse to change),
and set Amount to the number of universes you want to output.
Note: The official Artnet/sACN will only output to one network card and will not output to 127.0.0.1 simultaneously, so the same network card needs to be selected in 3D software. In addition, because our box's network bandwidth is only 10M, if it is just for 3D rehearsal, it is recommended to choose the built-in network card. If you need our box to control actual lighting, then our box's network card must be selected. At any time, there can only be Artnet data on one network card.

Note: Although it is possible to unlock 1000 universe, setting too many universes will consume a large amount of network bandwidth and computer resources. It is recommended to set the output quantity according to actual needs.

How to check MA3 unlocking parameters:
Click anywhere on the screen in MA3, Add Window will appear, select More to add the System Info window,
and you can see Parameter Count -> Available, which shows the number of unlocks.
As long as you can see the parameter count here, it indicates that the unlock is successful!


         hahan
    2026-06-03